Battery Box Support
Pull up latch and Open Lid
Connect wire labeled NEG to Black Negative terminal on Battery 1.
Connect wire labeled Jumper to Red Positive on Battery 1, and Black Negative on Battery 2.
Connect wire labeled POS to Red Positive on Battery 2.
Close lid and re latch, test your connections by switching the power to ON, If successful you will see a blue illuminated LED and the current voltage of your batteries.
NOTICE: There is a standard 10 AMP fuse located on POS wire to prevent damage to your box in case of short. Check and replace this 10 Amp fuse if the box fails to power on.
****USE 3.5 AMP MAXIMUM****
Steps For Charging
In order to keep your batteries full and long lasting it is recommended that you charge once a week.
NOTICE: If your charger comes with a switch labeled GEL-AGM, make sure the switch is set to AGM.
Plug in your UPG 24v 3.5 amp charger to port labeled Charge.
Turn on Power, you will see the Voltage jump up to about 29 Volts. This is normal until the batteries reach their full capacity. The charger will then go into float charge and your voltage range should be around 26-27 volts.
